PDA

View Full Version : Wall sweeps


Eric Wing
2006-10-10, 06:37 PM
Does any one know why I can't bring in a trim (.rfa) profile, and use it with the host sweep command?
dsw98
2006-10-10, 07:53 PM
Does any one know why I can't bring in a trim (.rfa) profile, and use it with the host sweep command?

Are you saying it won't load at all or that you can't get the profile to work after it is loaded?
Eric Wing
2006-10-10, 08:15 PM
Are you saying it won't load at all or that you can't get the profile to work after it is loaded?After it is loaded, I can't get it to appear as a choice when I start the Host swep command. I go to wall sweep, then to the wall sweep: cornice properties, modify it, and it dosen't show up in the profile. I may have just created the family wrong.
dsw98
2006-10-10, 08:45 PM
To create that new sweep, place an existing one on a wall. Then select it and create the new one. Your new profile should be there if it's loaded. Are you sure you created a Wall sweep and not a fascia or some other type of profile?
Eric Wing
2006-10-11, 10:57 AM
To create that new sweep, place an existing one on a wall. Then select it and create the new one. Your new profile should be there if it's loaded. Are you sure you created a Wall sweep and not a fascia or some other type of profile?
You know? I used a blank template. I should have just grabbed one that I KNEW worked and modified that.

hey, thanks a billion!!!!!