Shaft openings showing in RCP

[jguycote]

On Reflected Ceiling Plans, symbolic "X" of shaft openings are showing through the ceiling, even if the bottom of the opening is above the ceiling. I cannot find a way to get rid of them properly. Is this a bug?

Changing the view range does not slove the problem, because it also hides shafts that I want to see. I can draw white lines on top of the X, but if the shaft changes location, the lines do not follow.

Any suggestions?

Thank you
J G Cote

[luigi]

It is for sure a view range issue...if you have an occasional location where you don't want to see the shaft beyond the ceiling level, then just use "plan regions" to have a smaller area have a view range where the top and depth is set below the floor above the ceiling...that way the X of the shaft won't show up....




On Reflected Ceiling Plans, symbolic "X" of shaft openings are showing through the ceiling, even if the bottom of the opening is above the ceiling. I cannot find a way to get rid of them properly. Is this a bug?

Changing the view range does not slove the problem, because it also hides shafts that I want to see. I can draw white lines on top of the X, but if the shaft changes location, the lines do not follow.

Any suggestions?

Thank you
J G Cote