Need help with a funky stair

[dhurtubise]

Can anyone point me on the right direction to build the attach stair. The floor to top floor height is 7986 mm
Maybe Phil you're up to the challenget his morning ? ;-)

[greg.mcdowell]

For that I think you're going to need to create two separate stairs. You can't create a stair that crosses back over itself in Revit. As for the rest, should just be a series of curved boundary lines and radial risers.

[michael.deorsey]

Greg's got it exactly right. I would make the break at the landing, as that is a nice flat location to break the stair, and then you can just sketch it out with the boundary and riser lines. I would not even attempt to use the run tool as a start, once you start making risers it will give you the count of how many you have remaining.

Good luck
Mike

[gravelin]

Ça donne quelque chose comme çà

MAkes something like that

[dhurtubise]

Ça donne quelque chose comme çà

MAkes something like that


Ouais, c'est pas mal ça. :-)
Tu peux me dire la procédure que tu as utilisé ?

[dhurtubise]

Ça donne quelque chose comme çà

MAkes something like that


Ouais, c'est pas mal ça. :-)
Tu peux me dire la procédure que tu as utilisé ?

[gravelin]

J'ai placé ton dessin en fond de plan.
placé un niveau à la hauteur que tu donnes.
J'ai mesuré la hauteur de marche que tu souhaites pour pouvoir la règler dans l'escalier.
J'ai ensuite coté tes cercles dans les esquisses (pour avoir les centres)
j'ai fais une première volée avec le palier
j'ai placé un niveau intermédiaire sur ce palier
j'ai fait la seconde volée et troisième volée dans le deuxième escalier. (toujours en utilisant les cotes et des plans de repère pour trouver les centres.)
j'ai simplement du faire un type d'escalier avec des marches épaisses, car le monobloc ne marche pas (comme toujours)

[Adam Mac]

That's exactly what i was going to say....... i think......?? (LOL)

[nandini]

you can do a stair the way you want with normal boundary and riser...what was the problem and y two stairs??!

[gravelin]

That's exactly what i was going to say....... i think......?? (LOL)Les grands esprits se rencontrent *:lol:

First I linked the DWG file
created a level at the height you're asking for
Measured the riser height on the DWG, to set it in the instance parameters of the stair.
Then I placed dimensions on the circles (to visualize the center)
I made the fist run with the stage (google translation??)
And made sedonc and third runs
I just needed to use a stair with thick riser because monolithic stair doesn't work (as always)

*Great spirits meet.

[Adam Mac]

Thanks for your trouble Gravelin - much appreciated!