Flat/Slope setting?

[shaunamorain]

RE: landing without another run

Attached is an example...pay close attention to the sketch lines of the stair and railing. Their Flat/Slope setting is altered. Also look closely at the stair properties.
Attached Thumbnailshttp://forums.augi.com/attachment.php?attachmentid=22283&stc=1&thumb=1 (http://forums.augi.com/attachment.php?attachmentid=22283)
Attached Fileshttp://forums.augi.com/images/attach/rvt.gifStair Landing.rvt (http://forums.augi.com/attachment.php?attachmentid=22282) (656.0 KB, 31 views)
Last edited by Steve_Stafford : April 19th, 2006 at 08:48 PM.

Can someone spell out where the flat/slope setting is in the stair properties dialogue box, I've scanned it over and over & can't seem to find it ! :Oops:

Thank you!!!!
Shauna

[greg.mcdowell]

It's in the "Options Bar"... in the same line as the Type Selector.

[shaunamorain]

OH! it's not in the properties, it's on top of the screen when in edit/creating mode- gotcha!


Thank you!