Rise/Run Default?

[msg4amer]

This may be obvious, but I sure can't seem to find it. How do you set the default rise/run for the roof pitch?

Thanks,
Amer

[aaronrumple]

Start a roof. Select lines. Before you start drawing the first line, open the lines property and set the Rise/12".

[rhys]

OR If you've already drawn a roof Select the roof and then edit, The roof outline is displayed in magenta. Select the roof edge that controls the pitch, look at the options bar to select defines pitch and adjust the pitch angle in the property box.

[Scott D Davis]

Or, in 6.1, you can now change the slope while in sketch mode right on the model. On slope-defining lines, the slope value is displayed next to the slope symbol. Click it, and you can type a new value right there.