View Full Version : Single Flush Door With Transom
jason.combs
2006-11-08, 07:33 PM
I need help with some phantom line that occurring in my door family. I have a door with a transom and there seems to be a phantom line that is mucking up the thing.
Also, I have a problem with the constraints. Changing the transom height does not work right.
Any guidance is appreciated.
eddy.lermytte
2006-11-08, 10:43 PM
Jason
You forgot to constrain the trim.
The ghost line is an extended trim edge.
jason.combs
2006-11-09, 01:31 PM
Thanks. Did you constrain the trim in plan view?
Also, if I change the transom height, the constraints are not satisfied. I had this working at one time, but have a hard time understanding the order of operation to properly constrain this.
Any ideas on this?
eddy.lermytte
2006-11-09, 03:23 PM
Jason
Yes I did.
About the Transom Height... the Int. Trim was not constrained well.
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.