dmb.100468
2006-12-12, 10:08 PM
I am trying to make a 208V, 1ph (2 poles) connection but the load gets split onto Phase A and Phase B, so the panel displays 1/2 the True Load on each phase. If I uncheck Balanced Load in the connector properties and set the Appartent Load for each phase then the connector's Total Load is twice what it should be.
I wrote a formula to get the Apparent Loads correct across both "poles", but the Total Load is still inaccurate.
Anyone else run into this? I have a post to the wish list for true 208V single phase capabilities.
I wrote a formula to get the Apparent Loads correct across both "poles", but the Total Load is still inaccurate.
Anyone else run into this? I have a post to the wish list for true 208V single phase capabilities.