Round staircase

[Anthony Miguel]

Hello
I would like to know if it's possible to create in REVIT a round staircase that turns more than 360°. When I create my boundries, the lines overlap, which is impossible. My stairs have a radius of 0.95 m and my the height between floors is 2.90 m.

[jeffh]

It is not possible to have a stair or ramp that wraps more than 360 degrees. You will have to model this condition with multiple stair objects.

[ijnicholas]

You could create one half circle stairs that takes you to half the floor to floor height. Then you could copy this stair and stack it on top of the first one and rotate it accordingly.
To make it easier, you might have to create a separate "level" at half height. (this datum is just for reference, and so does not need to have a floor plan associated with this.)
HTH
meendum santhippom.

[Anthony Miguel]

It is not possible to have a stair or ramp that wraps more than 360 degrees. You will have to model this condition with multiple stair objects.

Thanks Jeff
I hope Autodesk takes this into consideration in the next release of REVIT!