Callout Errors

[ford347]

I was placing a number of callouts in a section and everything was going fine. I then tried to place a callout and the error attached to this thread popped up and it would not let me place the callout. Maybe it has to do with the view depth of the section. The section I am working in is a split section about four times. When trying to place this callout, it was on a different wall than the ones that work, but I have no idea. Has anybody ran into this before???!!!!

Josh

[ford347]

Turns out a callout in a split section when dealing with very little space is hard to control. I'm sure if I knew more about scope boxes etc., this may be easier. I've resorted to just drawing detail sections in plan view where I needed them, that way they show up as callouts in my section view and I just went from there.

Josh