krista.manna
2006-12-18, 05:28 PM
I'm actually asking this question for a coworker who's just started in revit & doesn't know about AUGI.
In order to create a triple run stair she created a "landing" by making a floor plate with a sweep to create the stringer. The issue is that the stringer of the stair does not meet properly with stringer around the "landing". It needs to continue so that the stringers meet at the same point.
Please advise.
-K-
In order to create a triple run stair she created a "landing" by making a floor plate with a sweep to create the stringer. The issue is that the stringer of the stair does not meet properly with stringer around the "landing". It needs to continue so that the stringers meet at the same point.
Please advise.
-K-