Exporting Masses to DWG

[Neil Osher]

So apparently it is NOT possible to export masses to DWG. Is this true?


I'm in 3d view
"Show Mass" button is activated.
Export to 2007 DWG > export as ACIS solids

If anyone can shed some light on this, it would be greatly appreciated.

Thanks.

Neil

[Scott D Davis]

Did you happen to see this dialog box when you tried to export masses? Basically, you have to have the Masses turned on in Visibility...simply clicking the Show Mass button is not enough to get them to export.

[Neil Osher]

Thanks Scott.

Apparently the "Do not show this message again" was checked. I had also forgot there was a mass category in the Visibility settings. See what you get for assuming that "What You See Is What You Get"?

I'm going to start being presumptuous from now on instead.... ;)

Regards,
Neil