patricks
2007-01-04, 10:15 PM
Why is it when I try to place a vertical reveal in a wall, centered above a window or door or curtain wall with an arched top, it always gives me an error saying it can't cut the wall? I can place it slightly off-center just fine, then I have to pull the blue grip handle off the edge of the opening just slightly, and then move it into position over the center of the arch.
Also, after getting one in place, I cannot copy it. If I try to copy it over to the next window, it just automatically deletes the copy.
Anyone else run into these problems?
Also, after getting one in place, I cannot copy it. If I try to copy it over to the next window, it just automatically deletes the copy.
Anyone else run into these problems?