Wall sweep cleanup

[jeff.95551]

I've got this condition that I can't fix for the life of me - a wall with a sweep - basically a wrapped column - three walls that wrap. One corner cleans up fine, the other doesn't. I've re-drawn it, erased one, then the other- the properties are identical. I just can't figure it out. Any ideas?

[lev.lipkin]

It looks to me that someone pulled the end of wall sweep id 131671 beyond the extents of the wall, most likely by mistake.
Pick on the wall to modify. Pick on end control of wall sweep and pull it back: it would snap to geometry of joined wall.
Hope this helps.

[patricks]

I bet the reference point of the sweep profile on each wall is not in the same place. They need to overlap in order to get the sweep to miter properly.

[jeff.95551]

Thanks! I had no idea that the sweep could be controlled apart from the wall. I'm sure I thought I had the wall end instead of the sweep end.

[natew]

I have a wall sweep wrapping a pilaster.
One side automatically miters, and the other does not.
I'm simply trying to clean up and miter both pieces at the corners.

Anyone have any suggestions?

Thanks!
nate