Filters don't work with annotations?

[patricks]

I created two elevation types, interior elevations and exterior elevations. I was hoping to be able to set up a filter to turn off all interior elevation marks, or all exterior elevation marks, in certain views. Is this not possible? Any other way to do it that doesn't use filters?

[lev.lipkin]

Filters are usually applicable to schedule-able elements (using schedule-able properties).

Elevations could be turned off based of view scale (instance parameter 'Hide at scales coarser than', similar to sections), or individually.

Hope this helps.

[Nelsonnc24]

The work around you can do is to create workset that is off by default and place your elevations in the workset that is turned off by default.
Have a look at this LINK (http://www.cadplan.co.za/techforum/viewtopic.php?t=728)