angelo
2007-01-12, 05:55 PM
I'm tearing my hair out with a large project. Some adjustments are being made to walls around the building by the rest of the team, but they are communicating whenever this occurs.
However, my ceilings seem to be affected by ANY change. On an entirely different end of the building, I find that a grid or ceiling perimeter has moved/adjusted. I can understand that if a wall is moved that any adjacent ceilings will be affected, but seemly completely unrelated areas are being affected.
This doesn't go over too well, when the entire building has been "completed" for printing, and then we find shifts to grids in many, many areas!
Any way I can pin ceilings, or make it harder for them to move on their own?
Thanks,
Angelo
However, my ceilings seem to be affected by ANY change. On an entirely different end of the building, I find that a grid or ceiling perimeter has moved/adjusted. I can understand that if a wall is moved that any adjacent ceilings will be affected, but seemly completely unrelated areas are being affected.
This doesn't go over too well, when the entire building has been "completed" for printing, and then we find shifts to grids in many, many areas!
Any way I can pin ceilings, or make it harder for them to move on their own?
Thanks,
Angelo