ACAD 2007: ETrasmit - Failed to load transmittal component: incorrect registry entry

[pwilson.112560]

Hi all -

When I try to e-transmit from Acad 2007, I get the following message: "Failed to load transmittal component: incorrect registry entry." I googled that phrase, to no avail, and haven't found anything on here. E-transmit works fine from Acad 2006, and this problem is pervasive on all the computers in our office. I'm guessing it's something in our installation. Thoughts?

Thanks, as always.

Pete Wilson

[Mike.Perry]

Hi

Look at running a Repair Install on your AutoCAD 2007 installation.

Do you run any kind of Registry Cleaning software or the like ?

Example, take a look at the following thread in the Autodesk Discussion Groups...

Etransmit command does not work (http://discussion.autodesk.com/thread.jspa?messageID=5017568)

Have a good one, Mike