bheng
2007-01-19, 12:50 PM
I noticed that when i cut a section through a topography, the section cut (hatching of the "earth") ends just below the 0 level datum line.
I have checked the crop regions and they have been turned off. also no scope boxes.
is there a way to display the sectional earth hatch further below the 0 datum level? (eg -3000 RL ?)
I have checked the crop regions and they have been turned off. also no scope boxes.
is there a way to display the sectional earth hatch further below the 0 datum level? (eg -3000 RL ?)