Knob made in AutoCAD 2004

[Deogan]

Knob Made in AutoCAD 2004

[Opie]

Nice.

What would this knob be used for?

Anything you would like to share on the steps you used to make it?

[ronie_ernanto]

Knob Made in AutoCAD 2004
Why you not render it?
Good work.




Nice.

What would this knob be used for?
Looks like stove knob.



Anything you would like to share on the steps you used to make it?
I guess first time is make a circle for the base of knob and extrude it.
Then a trapesium for the handle and extrude. In A2004 need to change UCS orientation before to do that. Champer the top side. And then union both part. After that, fillet the edge where the base and handle meet. Fillet the circle edge of the base. Last, fillet the edge of the handle. Done.

[Deogan]

Thanks For Replying Knob

I made this just for Practicing The Fillets!!!