View Full Version : Elevation does not reflect changes
abink
2007-02-07, 04:03 PM
I've made some changes to my north facade, working on the floor plan. When I switched to view the changes I've done on the north elevation, the changes did not show up at all. They did show up on the east and west elevation though.
I ended up deleting the north elevation tag and placing a new one, that did the trick.
Still - what was going on with my 'old' north elevation tag?
Thanks,
Axel
Justin Marchiel
2007-02-07, 04:08 PM
hard to say. are you using things like phases? i could see if the elevation was set to exisiting and you made changes to the new, they would not show up.
That does seem kind of weird.
justin
abink
2007-02-07, 04:26 PM
I am using phases and I did consider that being the problem, but I copied an element that did show up on the north elevation, thinking that a copy of an element that already shows HAS to show up as well.
When I switched back to the elevation view, the original piece showed up and the copy did not...I'm biting my butt because I did the copying on the floor plan view and not on the elevation view...that might have cleared up things.
Justin Marchiel
2007-02-07, 04:42 PM
well with phase, if you are in a new phase and copy and existing item if will go to the new phase. that would explain that the copying error
Justin
abink
2007-02-07, 05:02 PM
I kind of doubt it - I only have two phases [existing and new construction], and all views are set to new construction and so is the element I copied.
If it happens again I have to remember to work on the view that is not showing newly made elements. I'll post the new findings asap.
Thanks for you help!
Axel
Mike Sealander
2007-02-07, 07:05 PM
I think it's a bug.
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.