PRINTING 36X24 sHEETS

[pwmsmith]

I have a HP1050C plotter and I'm using a 36x24 titleblock sheet. Its the standard one from Revit. However my sheet are cutting at 23". Any ideas?
Thanks

[Paul P.]

Pat, try looking up the thread "Plotting - save paper and your brain” (06-24-2004, 02:29 PM) by Metanoia (Wes Macaulay) that might help.

Regard’s, Paul.

[pwmsmith]

Will do.
Thanks Paul

[bclarch]

We have an HP 750C+. It has an option under the "Advanced" settings tab called "Inked Area". If this is checked then the plotter saves paper by cutting the roll immediately after the last bit of ink is printed on the sheet instead of waiting for a page break. Perhaps your HP plotter has a similar setting than you need to uncheck.