Updating Templates to have Fields

[akasten]

To all who may help,
I have numerous templates to update and I have run into a little problem I think. Ok, here is the problem. My templates show up with ###### this where my fields are. Now this is when I just open my templates and not when I create a new drawing from a Sheet Set. I read that they are supposed to show as whatever you have placed in the default value. Is this supposed to happen or is there a problem going on. I follow all the steps and all of my templates end up with those pound symbols. Well everyone except for 2 out of the 12. If you want me to list what steps I go threw I will. PLEASE HELP!!!!

[mjfarrell]

As they work correctly when you actually use them
I would accept them as they are.

However this document explains the problem and solution clearly
enough: http://usa.autodesk.com/adsk/servlet/ps/dl/item?siteID=123112&id=4247081&linkID=2475176

[akasten]

Well I believe I found out why. My .dst file was in a different location then where my templates were being held at. So I moved my templates in the same location as the .dst files.