dmb.100468
2007-02-15, 07:25 PM
It would be nice to have control over the visibility and location of homerun arrows on wiring. When wiring between devices on separate circuits I don't always (actually never) want the arrow at the end of the wire where it connects to the device. I'd rather show it somewhere along the wire where it may be more readable, especially if I tag it.
When doing a receptacle layout with multiple circuits we often tag each device with its circuit number and therefore do not even show the homerun arrow between devices, only at the actual homerun. Being able to turn arrows on or off like the tick marks would be very helpful.
Thank you.
When doing a receptacle layout with multiple circuits we often tag each device with its circuit number and therefore do not even show the homerun arrow between devices, only at the actual homerun. Being able to turn arrows on or off like the tick marks would be very helpful.
Thank you.