Steve_Bennett
2007-02-17, 06:14 AM
I have a window series (elevation view) that starts at say 24" wide with 1 mullion down the center (vertically). As it grows in width, the mullions increase in quantity and become 2 instead of 1. The 2 new mullions are offset equally from the center of the original one.
How should I approach this? I thought about cheating and using a visibilty state, but wondered if there was a way to do this with paramters/actions. I thought about possibly using a lookup paramter/action to tie together a move/array combo, but not quite sure the best way to go about this. Suggestions? picture attached.
How should I approach this? I thought about cheating and using a visibilty state, but wondered if there was a way to do this with paramters/actions. I thought about possibly using a lookup paramter/action to tie together a move/array combo, but not quite sure the best way to go about this. Suggestions? picture attached.