View Full Version : Setting section view elevations
anthonyherrera
2007-03-08, 07:30 PM
Is there a way to set the elevation limits (both min and max) when displaying multiple sections? I have two surfaces being displayed, but some of the section views are displayed all the way down to zero. When I view the properties of both surfaces neither have a zero minimum elevation. Thank you for any help.
MMccall.83699
2007-03-08, 11:15 PM
I don't know what causes this but, re-sampling the surfaces should make it go away.
There is no way that I know of to manually control the elevation range in a cross section.
MHultgren
2007-06-11, 09:10 PM
In your panorama, are there any error or warning messages that a target could not be located? Sometimes, the alignment itself will pick up a point that is at elevation 0. Another thing to check is zoom to a window with coordinates -1,-1 to 1,1 and see if there is a floating point or symbol there. It may be connected to the erroneous sections. I have found these and erased the object, then rebuilt the sections and the problem went away
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.