PDA

View Full Version : Shared toposurface point elevations?



patricks
2007-03-26, 04:01 PM
Problem: I have a building model, relocated to a shared location of 100 feet above sea level (finished floor). So the levels report 0 if set to project, 100 if set to shared. The toposurface contour labels also report +/- 100 feet, as they are set to shared. However, when editing the surface or doing a graded region, all the internal points report Project elevations of 0, 1, 2, 3 feet above finished floor, etc.

One workaround I have done is to actually move the building up 100 feet, so that the internal points will read 100 feet, or above or below.

But no one likes to move the whole building. How can I get the internal points to report point elevations relative to the real world shared coordinates?