Ceiling Height Tags

[jesus.plata]

When i place my ceiling height tag it does not place the tag where my cursor is. It usually defaults to an edge/border of the ceiling and I have to hunt it down and maually center it in the room. Any advice on what I may be doing wrong?

[Justin Marchiel]

try starting with a leader. it will then tag the edge of the ceiling and then you can place the tag where you want. then uncheck the leader after it has been placed.

Justin

[jesus.plata]

I have multiple ceilings at different heights. The tag gets lost in the RCP among the lights and dims, even if i start off using a leader I still have to search the drawing to find where revit placed the tag. Is there not a tag that will embed where you click your cursor?

[ron.sanpedro]

I have multiple ceilings at different heights. The tag gets lost in the RCP among the lights and dims, even if i start off using a leader I still have to search the drawing to find where revit placed the tag. Is there not a tag that will embed where you click your cursor?

You might try making your tags show up bright red and thick while you place them, then switch back to something rational for printing.

Gordon