Levels and Dimensions

[harkeychad]

Well I am into CDS and just noticed my Lower Level is at the wrong elevation. I have looked to see if any of the levels are locked and they are not so I tried to move the Lower Level down but it moves all my levels above with it. I only want to move that Level down. I tried to lock all of the other levels together but they still move. Any suggestions

[sbrown]

did you array the levels to create them? there must be a locked dim somewhere.

[harkeychad]

I did not use the array. So basically you are saying I need to go through all the dwgs to check to see if I have the lower level locked with some other level?

[aaronrumple]

I did not use the array. So basically you are saying I need to go through all the dwgs to check to see if I have the lower level locked with some other level?
No. Pin the other levels. Then move the first level. This will then pop up an error - Remove Constraints? Of course...

[harkeychad]

Thanks, I will try that

[harkeychad]

Aaron,

What do you mean by Pin the other levels. I know about the locks, but not Pins on Levels?

[aaronrumple]

Pin is on the top toolbar next to group...

[harkeychad]

Thank you. That did it.