Roof Material Takeoff

[kdsarch]

Has anyone every run into a problem with the roof material take offs? For some reason I am getting three lines of the same dataevery roof area. I can't figure out how to clear this up. The phase and filters are set correctly. Also, if I set up a roof schedule, that shows the correct roof areas.

Any ideas?

[muttlieb]

My guess is that your roof is made up of three layers of material and your takeoff schedule is reporting the area of each layer, hence the three lines of same data for each roof.

[kdsarch]

Thanks,

That is exactly what it was. I can run a filter to only show the shingles. Thanks