Ground Level Set To Zero

[Nealo]

I know this has probably been asked before, but I cannot find the answer:

I've got a topo surface made from absolute levels between 108m and 117m. My building is located on a at 110.5m, but I want the ground floor to read 0m instead of 110.5m.

Please let me know how I can do this?

[gordolake]

Hi Neal,

In a section / elevation view, try >tools >project location >relocate this project
click start point and move down 110500 - zoom all and the level should show read 0

Note that topo contour labels still show absolute levels as entered.

Hope this helps.

Steve

[Nealo]

Thanks Steve,

I must have set it the site up incorrectly as when I follow those instructions, the levels move, but ground level is still set to 110500.

Appreciate the help though.

[dbaldacchino]

Make sure your levels are reporting Shared Coordinates and not Project coordinates.

[Nealo]

Thats the trick David, beautiful!

Thanks for your help guys, I knew there was a simple way to do it but being a relative novice could not figure it out.

Cheers!