Curtain System...Corner Condition

[FWSchreck]

Hello:

Is there a quick technique to get panels within two curtain systems to mitre/join at a corner condition?

I've come up with 2 methods, both somewhat time-consuming:

(1) Move the endpoint of one of the systems so that its endpoint aligns with the inside face of the other panel.

(2) Add a face to the underlying mass that corresponds to a panel edge.

Any ideas/suggestions?

[aaronrumple]

You can actually edit a system panel to push/pull it to the point you want. However, this is time consuming. For schematic you can set the panel offset to the center of the system (or just back the panel width) and they will look a lot better. Or you can make a corner panel which has the correct offset to extend out and join. I agree - it is a but fussy. with as much butt glazing as is done today, I would hope Revit would improve in this area.