ykang
2007-04-03, 11:24 PM
Our designer draws in a "sketch mode" with "sketch mind" in autocad. AND he's too old to change his mind using snap.
Is there any way we can have his drawing converted automatically to 1/2" snap module or 1/4"?
I'm just sitting there trying to figure out every corner of his drawing is in snap or not.
As you know, this relates to dimensioning later on.
Is there any way we can have his drawing converted automatically to 1/2" snap module or 1/4"?
I'm just sitting there trying to figure out every corner of his drawing is in snap or not.
As you know, this relates to dimensioning later on.