Topo surface fill patern

[jbeaman]

Is there any way to change the hatch/fill pattern that the topo surface displays? It uses the ground pattern by default, but I would like to change that to a solid fill.

Thanks

[Max Lloyd]

Hi there.

Thats easy enough. go to settings, site settings, drop down the section cut material menu, then select, edit or make a new material that has a solid cut pattern to it.

you'll find that most subjects have been discussed before (this one was asked just yesterday) so it can often be helpful to do a search in the forums to see. The search facility is easy, simply press the search forum button (top right).

Hope this all helps your use of Augi!

Regards,

Max.

[jbeaman]

Thanks, I'll do a search before I ask next time.