Is it possible to combine two tables?

[Tom.Weinstein.137333]

Is it possible to combine two tables?

I can't even seem to copy/paste the cells needed. When I highlight the group of cells, I can right click and go to copy. But then, if I go to the table I want it in, if i click the upper left cell, in the manner I would in excel, the option to paste is not highlighted. If I use ctrl-v, i trys to insert the data as a new table....I'd rather not retype them...

[KansasCAD]

Hello,
Don't you just love tables?

I just tried what I think you are asking. If you hight an area of 3 rows by 4 columns, right click and copy, then in the destination table you need to highlight the same size area, in this case 3 rows by 4 columns, then right click and paste.

Note that longer cells in the original table will sometimes "stack" the text in the destination cell if the cell is too small. Just takes some experimenting.

Hope this helps,

Daryl