eric.anastas
2007-04-27, 08:24 PM
I have three phases in my Revit project
Exsisting - Before Construction
Construction - Durring Construction
Final - Finished building
I have seperate toposurfaces for each phase, an exsisting surface, a surface for construction that will show temporary construction routes, and a final surface that shows all the finished roads and sidewalks.
I'm running into a problem however. Revit is not letting me intersect sub regions on different toposurface objects that are in different phases. This doesn't make sense to me because they are seperate surfaces. Why would revit care if they intersect?
Eric
Exsisting - Before Construction
Construction - Durring Construction
Final - Finished building
I have seperate toposurfaces for each phase, an exsisting surface, a surface for construction that will show temporary construction routes, and a final surface that shows all the finished roads and sidewalks.
I'm running into a problem however. Revit is not letting me intersect sub regions on different toposurface objects that are in different phases. This doesn't make sense to me because they are seperate surfaces. Why would revit care if they intersect?
Eric