View Full Version : Quick select is not permitted in perspective view?
GreyHippo
2004-07-21, 02:24 PM
When I initiate the qselect command I receive the error in the title. I tried to dview, selected all objects, then typed off, still same error. What else can I do?
Mike.Perry
2004-07-21, 02:35 PM
Hi
Check out the following Technical Documents on the Autodesk web site under the Knowledge Base section -
ID: TS21997 - Switching between parallel projection and perspective view mode (http://usa.autodesk.com/adsk/servlet/ps/item?siteID=123112&id=2894555&linkID=2475323)
ID: TS17740 - Cannot draw objects or zoom after exiting 3DORBIT command in perspective view (http://usa.autodesk.com/adsk/servlet/ps/item?siteID=123112&id=2895464&linkID=2475323)
Have a good one, Mike
GreyHippo
2004-07-21, 04:11 PM
Those didn't help.
Mike.Perry
2004-07-22, 07:15 AM
Hi
From what you've described it sounds like you need to turn OFF Perspective View.
If you are doing that and still experiencing the issue/problem can I please suggest that you post the drawing file here (I assume Rightly or Wrongly this issue/problem is occurring within *only* one drawing file) so we can take a look.
Have a good one, Mike
GreyHippo
2004-07-22, 12:52 PM
here is the dwg it 2000i format.
again, the prblem is when I want to go into qselect.
thanks.
Mike.Perry
2004-07-22, 01:36 PM
Hi
Please find attached "QS_Problem_Fix.dwg", you should now be able to use ._QSelect within this drawing file.
Below is what I done to correct the drawing file -
Command: ._Dview
Select objects or <use DVIEWBLOCK>: _All
2027 found
1 was not in current space.
Select objects or <use DVIEWBLOCK>:
Enter option
[CAmera/TArget/Distance/POints/PAn/Zoom/TWist/CLip/Hide/Off/Undo]: _PO
Specify target point <1303549.211, 429745.035, 1.048E+99>: 0,0,0
Specify camera point <1303549.211, 429745.035, 1.048E+99>: 0,0,1
Enter option
[CAmera/TArget/Distance/POints/PAn/Zoom/TWist/CLip/Hide/Off/Undo]:
Regenerating model.
************
Check out the following Technical Document on the Autodesk web site under the Knowledge Base section -
ID: TS59340 - Plot or preview shows incorrect area of drawing when plotting limits (http://usa.autodesk.com/adsk/servlet/ps/item?siteID=123112&id=2880566&linkID=2475323)
Have a good one, Mike
GreyHippo
2004-07-22, 02:25 PM
That fixed it.
thanks mike
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.