PDA

View Full Version : Wall Sweep Problem



pashley
2004-07-21, 02:44 PM
I created a wall sweep using the cornice file as a template. I attached the sweep to the exterior of a wall and all was OK. When I tried to add another wall, however, the sweep will only attach to the interior side of the added wall. Flipping the orientation doesn't do anything. How do I get this to work? I don't want an in-place family. This is supposed to be a quick representation of a flat awning that is 4 feet deep and 8" high.

tamas
2004-07-21, 08:36 PM
When you add another wall to a wall sweep, the face of the wall closest to your pointer is the one that the sweep will use.

This usually means that you need to rotate the model in 3D to get closer to the face you want to select.