rotate and thin lines

[comhasse]

Can anybody confirm this?

I tried to rotate something in a floor plan, but the rotate tool didn't show the reference line anymore, and accordingly i couldn't snap to horizontal or vertical. Then i remembered that i had just turned off the "thin lines" category in V/G. Guess what? - The rotate tool's reference line is obviously a thin line. (This doesn't happen if you turn off the "lines" category).

WinXP, Revit 2008

[c-hawk]

Yep, confirmed! That's so silly, it's laughable. Please submit a support request to adesk.

[jeffh]

I have verified this behavior and logged it with development for investigation. Thanks!

[sbrown]

Note it also turns off if your active workset is one that is off by default or not visible.