matthews.137824
2007-05-23, 06:16 PM
Not sure if this is the place to do this, but I have a question that i just cannot figure out.
I am making a dormer through a roof - and the walls of the dormer are to be curved down and out - these curves are to be constructed atop the roof only - how can I model this within revit.
I have tried sweeps, and including the sweep right into the wall type - but everything i do the curve goes right through the roof and shows up on my second floor plan. I would like this to be accurately modeled in the project, and i do not want to "half ***" some sort of solution.
Thanks,
Brian
I am making a dormer through a roof - and the walls of the dormer are to be curved down and out - these curves are to be constructed atop the roof only - how can I model this within revit.
I have tried sweeps, and including the sweep right into the wall type - but everything i do the curve goes right through the roof and shows up on my second floor plan. I would like this to be accurately modeled in the project, and i do not want to "half ***" some sort of solution.
Thanks,
Brian