Civil - RCP crossing for profile

[jpaulsen]

The attached Dblock is for showing RCP pipe in a profile view that is exaggerated 10 times vertically. Thanks to marklabell for helping with the scale action.

I also attached the pipe specs used to fill the lookup table.

[SRBalliet]

Was this done in 2008? Can you save back to 2006 for us slow companies? I get a "Drawing File Is Not Valid" error message.

[fkellogg]

You have to go to the second message in the list":
"Sticky: Drawing Conversion Tool from Autodesk Chris.N "

I still have 2006, but after two download tries of "DWG TruConvert", I now just save others' Dblocks to a folder and use the "Convert to 2004 in place" option.
It takes just a few seconds.

C. Frank Kellogg
if you need anything else

[jpaulsen]

I did this in 2007. I will save it back to 2004 later this afternoon when I get in the office.

[jpaulsen]

Her you go. I did an export to AutoCAD 2004 from C3D 2008. Hopefully that works. Let me know if there are issues and I will save it again with Map when I get to the office.

[SRBalliet]

Thanks, I also downloaded that DWG TrueView, so I won't have this problem again.

[Civil Samurai]

Thanks, this may come in handy!