rdaniel
2007-06-14, 03:12 PM
You can probably tell that I'm an ADT user from my terminology in the title. I've been trying to join / clean-up an intersection of walls without much luck. I've tried joining, unjoining, cut geometry, don't cut, edit wall joins, trim, and combinations of all of the above. Maybe someone out there has a trick. I'm also wondering if I'm approaching it the wrong way. The real deal is I have a CMU wall with attached veneer and the stone wraps around the end and other side of the wall on the exterior. To accomplish this, I created a second wall type with veneer on both sides. Is there a better way to go about it.
Also, note that at the opening the stone veneer is only wrapping half-way through the CMU. Is this typical of how wraps perform or what?
Thanks for the help.
Also, note that at the opening the stone veneer is only wrapping half-way through the CMU. Is this typical of how wraps perform or what?
Thanks for the help.