View Full Version : windows in fill areas
i'm having a problem with placing a new window in an existing wall where there was originally a door that was demolished. the wall automatically filled in the hole where the door was removed but when i go to put a new window in the same location, it shows it in plan but in elevation it only shows the outline of the window but it's filled in with the brick wall. any ideas?
Scott D Davis
2007-06-20, 09:04 PM
Is the Phase Filter of your view in properties set to "show all"? if so, then infilled wall piece is still showing.
it's set to show complete
Calvn_Swing
2007-06-20, 09:50 PM
Lila, there was a post about this same issue just a day or two ago in this very forum. Do a search, or just look for it in the last few days of traffic. I can't remember what the resolution was, but there is a fairly easy solution.
Good luck!
Scott D Davis
2007-06-20, 10:18 PM
it's set to show complete
Set it to "Show Existing and New" and then the "demo" piece will go away.
do you mean "previous and new" i don't have "existing and new"?
Scott D Davis
2007-06-21, 04:13 AM
do you mean "previous and new" i don't have "existing and new"?
sorry, yes I meant previous and new! <slapping forehead> Long day...I was in a class when I responded earlier!
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.