Structural - Steel angles

[jstamnitz]

Some steel shapes...

-Jon

[jwlucasVT]

I was curious as to how I would go about changing the layers or colors (either is fine) to match our standards. If I open your angle in the block editor and either change the color or layer of your lines and then your hatch to match our standards then save it, the changes show up in the original drawing of the 1/8X2X2. As soon as I change the thickness of the angle, it goes back to the original colors. Thanks a lot for the blocks, the work great and are very helpful, I just need to figure out how to get them to show up as the colors we use. Any suggestions would be appreciated.

Thanks, John Lucas

[Chris.N]

I was curious as to how I would go about changing the layers or colors (either is fine) to match our standards. If I open your angle in the block editor and either change the color or layer of your lines and then your hatch to match our standards then save it, the changes show up in the original drawing of the 1/8X2X2. As soon as I change the thickness of the angle, it goes back to the original colors. Thanks a lot for the blocks, the work great and are very helpful, I just need to figure out how to get them to show up as the colors we use. Any suggestions would be appreciated.

Thanks, John Lucas
that's because he used visibility states instead of lookups & parameters for the thickness. you have to modify ALL the states to meet your standards.

[jwlucasVT]

Thanks a lot, that did it.