How do you show door wwings on floor plans?

[TerribleTim]

Just a quick pole on how you guys handle door swings on your floor plan drawings. I was always taught to draw them with a hidden line. What do you guys use?

[CADDmanVA]

Just a quick pole on how you guys handle door swings on your floor plan drawings. I was always taught to draw them with a hidden line. What do you guys use?Hidden line with a CELTSCALE of 0.5. That's how we do it.

[cadtag]

very light continuous line, call it 000 Rapidograph

[Gareth.Penn]

Laziness has set in here.
There was a time on the drawing board when I would use a 0.18 pen dotted line for the swing and 0.35 for the door. These days they are drawn on the layer A315-doors (colour red, pen 0.18 )

[TerribleTim]

So far that's 1 vote for a hidden line, and 1 vote for continuous. The other one didn't say what line type.

[cadpro78]

So far that's 1 vote for a hidden line, and 1 vote for continuous. The other one didn't say what line type.

For door swings we use ADT2006's door layer "A-Door" and it is continuous line at a light lineweight. However, we do sometimes put doors as hidden if it is on a demolition plan to show it is being removed from the building.

[drafting.33933]

I use hidden line, 0.18mm for swing and continuous, 0.25mm for the door and jambs. They are both on one layer.