Only some topo lines won't print?

[formarch.70565]

I've created a graded region with and elevation change of about 25 feet or so and everything looks great on the screen. The site setting are set to 2' intervals with 10' increments and thats the way it looks on the screen. However when printed portions of topo lines are left off within a certain range. Specifically, my topos range from 2534 to 3558 but lines 3542, 3548 and 3550 are only partially printed. Line 3544 prints fine.


Has anybody experience this issue?

thanks

[brett05]

I haven't experienced this, but I would try to eliminate the printer first by printing to PDF or DWF and compare that to your hardcopy printed earlier. If these print OK, then it could be a printer driver problem. Just a stab in the dark.

Cheers, Brett

[balazs.trojak]

Did the change of printer resolve this? I am having a similar issue with topo surfaces in sections showing up their projected edges, despite being far out of the scope of the section. Strangely they are not on screen, but on the prints/previews only.