Reveal Misbehavior

[hawk0148]

I'm having some issues that I can't figure out involving some reveals on a project I'm working on. One of them is a spot where if I add a small wall segment it destroys the reveals on a different wall. I've created two screenshots of the situation, before and after the wall has been added. What would be the cause of this?

Additionally, is there a special procedure at doing reveals on the edge of cut openings? I've been having them either not appear at all, say 'failed to cut wall', cut above and below the opening but not on the opening edge, or just inexplicably work correctly. Any ideas?

Thanks a lot for any responses!

[dfriesen]

Additionally, is there a special procedure at doing reveals on the edge of cut openings? I've been having them either not appear at all, say 'failed to cut wall', cut above and below the opening but not on the opening edge, or just inexplicably work correctly. Any ideas?The profile you're using for your reveal should have the origin point at the side rather than in the middle of the reveal, so that the edge that's defined by that point is continuous past the opening. (You'll be able to mirror the reveal for the opposite side of the opening.)

[hawk0148]

That is actually what I have been doing, the reveal profile is a very simple 1/4"x1/4" triangle, and as far as I can tell the edge is continuous. Got any other tricks? :)