ledis_nomad1817
2007-07-20, 02:51 PM
This just developed yesterday (see image) and I can't find the problem. I extended one mullion to show that both extended or retracted, the horizontal mullion doesn't meet the corner mullion correctly. Any ideas?
On a related note, I'd like to make my curtain walls such that the panels are of uniform size vertically (ie, each panel is 1250mm tall). I can't seem to figure out what settings to use (fixed number, fixed distance, account for mullion size, etc) to make this happen because the top and bottom panels are measured differently than interior panels.
On a related note, I'd like to make my curtain walls such that the panels are of uniform size vertically (ie, each panel is 1250mm tall). I can't seem to figure out what settings to use (fixed number, fixed distance, account for mullion size, etc) to make this happen because the top and bottom panels are measured differently than interior panels.