Architectural - Wall Section

[bshank.140587]

A few DBs used in wall section details

[Rico]

A few DBs used in wall section details

The ONLY comment I can add to this is that you appear to have forgotten the array function for the "Custom Size" vis state in your Batt Insulation Block.

But I really like the way you tackled the dreaded "Taper Insulation" Issues.

I've been trying to figure out a way to make that part dynamic too and it looks like this is the only option.

Well done! :beer:

[bshank.140587]

Hey Rico,

Thanks for your comments. The array function was left out of the custom size since the custom size is based on a scale factor. I havent yet figured out how to get the array distance to follow a change in the linear parameter (Is it even possible?) So, if the array is setup in the default state, it will only array the default distance even after you scale it. Clear as mud, lol.

Brent

[Rico]

Hey Rico,

Thanks for your comments. The array function was left out of the custom size since the custom size is based on a scale factor. I havent yet figured out how to get the array distance to follow a change in the linear parameter (Is it even possible?) So, if the array is setup in the default state, it will only array the default distance even after you scale it. Clear as mud, lol.

Brent

you should check out the one i did. it's in here somewhere. and the way i tackled it is that you change the scale via the properties window. otherwise, the block goes nuts.