rvitkauskas
2007-08-14, 05:26 PM
OTRACK works fine in 2d, stooped working in 3d. 3dpoly does not follow other lines directions. Extend it's stop working properly too.
After snapping to endpoint, it shows that it is extending, but extensions are happening in X & Y coordinates.
Anybody had this problem???
Spend 2 days finding a solution, can not find anything.
(in AutoCAD 2008)
After snapping to endpoint, it shows that it is extending, but extensions are happening in X & Y coordinates.
Anybody had this problem???
Spend 2 days finding a solution, can not find anything.
(in AutoCAD 2008)