Tyveka
2007-08-16, 02:43 PM
Good day everyone,
We have an issue where our mechanical consultant did their drawings in AutoCAD, whereas we did our Architectural model in Revit.
The problem we are now facing - we have rooms on the same level with different ceiling heights and some rooms have open ceilings while others don't. We want to show the diffusers and ductwork in the ceiling plan where it shows up, hiding the ductwork where the ceiling hides it.
How would we go about doing this without "re-drafting" all the mech stuff in Revit?
Thank you in advance for your suggestions.
We have an issue where our mechanical consultant did their drawings in AutoCAD, whereas we did our Architectural model in Revit.
The problem we are now facing - we have rooms on the same level with different ceiling heights and some rooms have open ceilings while others don't. We want to show the diffusers and ductwork in the ceiling plan where it shows up, hiding the ductwork where the ceiling hides it.
How would we go about doing this without "re-drafting" all the mech stuff in Revit?
Thank you in advance for your suggestions.