wfrst2008
2007-08-22, 12:24 AM
I want to draw a 3d line to join two points with different XYZ values and then
use this line to construct a sweep in place family.
However, Revit doesn't allow me to snap the points (actually they are small circle
constucted in acad and then import to Revit)
How can I do that ? Any ideas ?
use this line to construct a sweep in place family.
However, Revit doesn't allow me to snap the points (actually they are small circle
constucted in acad and then import to Revit)
How can I do that ? Any ideas ?